Changing two Report Viewer Components

Hello Sam,

It’s possible to update both report viewers, however you would need to use a “Flow Run Part” component on the page instead, and have the report viewers both use two different selection bus names. Below are a few links on that provides examples of using a “Flow Run Part” in Decisions, along with a helpful forum post on how to setup a report viewer to dynamically change what report is shown.

[url=https://documentation.decisions.com/docs/flow-run-part]https://documentation.decisions.com/docs/flow-run-part[/url]
[url=https://support.decisions.com/forum/topic2342-displaying-dynamic-reports.aspx]https://support.decisions.com/forum/topic2342-displaying-dynamic-reports.aspx[/url]

In the “Flow Run Part”, we can specify or design a flow to navigate/refresh the page with updated values to the selection buses. This can be done using an EndForm Session step, setting the option to navigate, and specifying the parameters, which will be the two Selection Bus Names. Below is a screenshot of the selection bus defined on the report viewers, and how it is setup in the End Form Session step.

[img]att4[/img]
[img]att3[/img]
[img]att2[/img]